Desert EdgeTruArc Firmware
CHECKING RELEASE…
Browser installer / ESP32-S3

Update the field computer. Not your blood pressure.

Connect TruArc by USB and install official firmware directly from this browser. Nothing is uploaded from your device.

Recommended

Update firmware

Writes only the application image. Leave Erase device off to preserve stored data when the release uses the same storage schema.

Web Serial is unavailable here. Open this page in a current desktop Chrome, Edge, or another browser with Web Serial enabled. Firmware installation requires a secure HTTPS connection.
Recovery

Factory install

Reinstalls the bootloader, partition table, and firmware. Use this for blank boards or recovery—not routine updates.

Web Serial is unavailable here. Open this page in a current desktop Chrome, Edge, or another browser with Web Serial enabled. Firmware installation requires a secure HTTPS connection.
Three-minute procedure
  1. Connect USBUse a data-capable USB-C cable. Close Arduino Serial Monitor or anything else using the port.
  2. Choose the portSelect the USB serial device when your browser asks. Hold BOOT only if connection fails.
  3. Keep it connectedDo not unplug or close the tab until installation completes and TruArc restarts.
Before you start: use Update for normal releases and leave Erase device off. Byte preservation cannot rescue incompatible storage-schema changes; release notes must identify migrations. Factory install may erase all device data. This installer accepts only the TruArc ESP32-S3 build—not Impact Mini or unrelated boards.